Hubbardton Forge 204795 - Manual

Installation Instructions
B261
Dune Sconce 20-4795 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27144 Rev A
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Prepare Fixture (Figure 1)
Component Parts
A Decorative Front
B Fixture Body
C Wall Mount Bracket
D #8 Black Pan Head Screws (6)
L #8 Pan Head Screws w/ lock washer
1. Carefully unpack the fixture from the
carton.
2. Remove black pan head screws (D) from
Fixture Body (B) and remove decorative
front (A). Set aside for later use.
3. Remove pan head screws w/lock washer
(L) from fixture body and remove wall
mount bracket. Set aside for later use
To Mount Fixture to Wall (Figures 2 & 3)
Component Parts
B Fixture Body
C Wall Mount Bracket
E Anchors
(2)
F # 10 Screws (2)
G Green Ground Screw
H Cupped
Washer
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Center the wall mount bracket (C) over the electrical
box being sure to hold it plum and level. With a
pencil, mark the location of all mounting holes in the
wall mount bracket on the wall behind.
IMPORTANT: Wall mount bracket must be secured
to a solidly mounted electrical box and/or a framing
member in at least two locations. Do not depend on
drywall anchors alone to support this fixture. If in
doubt, contact a qualified electrician.
Put the wall mount bracket down and drill 1/4" holes in the locations marked on the wall. For holes using anchors,
place the tapered end of the anchors (E) into the holes and gently tap them flush to the wall using a light weight
hammer.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)