Hubbardton Forge 18810 - Manual (Page 2)

Assembly & Installation Instructions
A96
Formed Glass Pendant Page 2 of 3
Complete Assembly and Install Fixture (Figures 3 & 4)
Component Parts
H Canopy J Canopy Pipe L Clutch N Fixture Pipe
I Canopy Ring K Plastic Sleeve M Set Screw
(Figure 4)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Place Canopy (H) over Canopy Pipe (J), followed by Canopy Ring (I). Make sure
smaller diameter side of Canopy Ring is oriented up toward the Canopy.
2. Thread the wires from the fixture pipe (N) into and through the canopy pipe (J).
3. Unscrew the clutch (M) from the fixture pipe (J) slide it across the wires and onto the
canopy pipe (D). Follow this with the plastic clutch sleeve (C), oriented so the tapered
end of the clutch sleeve nests in the clutch.
4. Slide the canopy pipe (J) as far as necessary to give you the total length of the fixture
which you desire. Be careful not to scratch the pipe surfaces and to pull excess wire up
through the canopy pipe (J). There must be a minimum 1-1/2" of inner pipe inside the
outer pipe. Hand-tighten the clutch to temporarily hold this adjustment. The clutch is
not securely fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the plastic
clutch sleeve is oriented toward the clutch when assembled and securely tighten set
screw (Figure 3).
5. Carefully slide Canopy Ring (I) and Canopy (H) down over fixture pipe (N) until they
rest on the fixture.
6. Using two machine screws (not provided), fasten the crossbar (I) to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
7. Using suitable wire connectors (not provided), connect fixture wires to supply wires
(white to white supply, black to black supply, and bare copper to bare copper or green
supply). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is
exposed.
8. Slide fixture canopy (H) against ceiling, and secure with Canopy Ring (I).
9. Refer to instructions on next page to install glass, light bulb and protective barrier.
(Figure 3)
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19500