Hubbardton Forge 18725 - Manual (Page 3)

Assembly & Installation Instructions
A336
Apparatus Pendant 18725 Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28310
To Install Glass (Figures 4)
Component Parts
K Bulb
L
Glass
M Thumb Screw
N Shield
1. Install bulb (K). Be careful not to touch bulb with bare hands; oil from the hands
will dramatically reduce bulb life.
2. Screw shield (N) on to socket. Do not over tighten
3. Loosen the three thumb screws (M). It is not necessary to remove them from the
fixture.
4. Raise glass (L) until groove is aligned with thumb screws (M).
5. Tighten the three thumb screws (M) equal amounts until snug with glass (L). Be
careful not to over tighten.
6. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 4)