Hubbardton Forge 18667 - Manual (Page 2)

Assembly & Installation Instructions
A283
Brindille Single Pendant 18-667 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26721
8. Once the fixture is fastened to the ceiling, tighten the set screw (J) in clutch (I) firmly with hex wrench provided.
Only after the set screw (J) is tight should you install the glass.
9. Refer instructions following to install glass.
To Install Glass
(Figure 3)
Component Parts
K Barrel Knobs (3)
L Bulb
(Included)
M Bulb Shield
N Glass
O Socket
P Spider
1. Remove barrel knobs (K) from spider (P) and set them aside.
2. Install light bulb (L). Be careful not to touch bulb with bare hands; oil
from the hands will dramatically reduce bulb life.
3. Thread bulb shield (M) over socket.
4. Raise glass (N) and align holes with spider (P). Fasten glass (N) to spider
(P) using barrel knobs (K).
5. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 3)