Hubbardton Forge 18667 - Manual

Assembly & Installation Instructions
A283
Brindille Single Pendant 18-667 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26721
Please Note: After installation extra hardware and accessories are possible due to our kits are used on multiple products
and options.
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Fixture Pipe
B Canopy
C Crossbar
D Ground
Screw
E Threaded Stud (2)
F Knurled Ball (2)
G Canopy Pipe
H Plastic Clutch Sleeve
I Clutch
J Set
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread the wires from the fixture pipe (A) into and through the canopy pipe (G) up
through the canopy (B).
2. Unscrew the clutch (I) from the canopy pipe (G); slide it across the wires and onto
the fixture pipe (A). Follow this with the plastic clutch sleeve (H), oriented so the
tapered end of the clutch sleeve nests in the clutch.
3. Slide the canopy pipe (G) as far as necessary to give you the total length of the
fixture which you desire. Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (G). Screw clutch (I) onto canopy pipe (G).
There must be a minimum 1-1/2" of inner pipe inside the outer pipe. Hand-tighten the
clutch to temporarily hold this adjustment. The clutch is not securely fastened at this
point; do not depend on it to hold the fixture.
Important: To ensure full connection
strength, be sure the tapered end of the plastic clutch sleeve is oriented toward the
clutch when assembled and securely tighten set screw (Figure 2)
.
4. Thread studs (E) through appropriate holes in crossbar (C) to match holes in
canopy (B).
5. Using two machine screws (not provided), fasten the crossbar (C) to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture
.
6. Using suitable wire connectors (not provided) connect fixture wires to supply (white
to white or ribbed and black to black or smooth). Run a pigrail lead from crossbar
ground screw (D) to the junction box and connect all ground
wires (bare copper or green to bare copper or green).
Caution:
Make sure wire connectors are twisted on securely, and no bare
wire is exposed
.
7. Slide canopy (B) over threaded studs (E) and push firmly to
ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with knurled balls (F). Be sure studs
are fully seated in the knurled balls.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)