Hubbardton Forge 137710 - Manual (Page 3)

Assembly & Installation Instructions
A126
For Steppe Pendant Fixture 13-7710 Page 3 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19910 Rev A
To Install to Ceiling (Figures 5)
Component Parts
E Ceiling
Bracket
I Set Screw (2)
J Canopy
L Crossbar
M Stud
(2)
N Lag Screw (4)
O Threaded Stud (2)
P Hex Nut (2)
Q Barrel Knob (2)
1. Thread studs (O) through appropriate holes in crossbar (L) to match
holes in canopy (J).
2. Using four lag screws (N) attach crossbar (L) to a structural member in
the ceiling, centering the crossbar over the outlet box. We've supplied
lag screws with your fixture; however, different materials and/or
construction methods may require different fasteners. If in doubt,
contact a qualified electrician. Do not attach crossbar directly to outlet
box.
3. Raise fixture to ceiling aligning studs in crossbar (L) with holes in
ceiling bracket (E).
4. Thread hex nut (P) onto studs (M) and tighten.
5. Using suitable wire connectors (not provided) connect fixture wires to
supply (white to white and black to black, and bare copper to bare
copper or green supply). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
6. Raise canopy (J) to ceiling over threaded studs (O) and push firmly to
ceiling, making sure that no wires are pinched between canopy and
ceiling. Fasten with barrel knob (Q).
Note: Be sure both swivel
notches are aligned in the same direction. For sloped ceilings the
notches should face towards the down side.
7. Once the fixture is fastened to the ceiling, tighten the set screw (I) firmly
with hex wrench provided. Only after the set screw (I) is tight should
you install the glass.
(Figure 5)
8. Refer instructions below and install glass.
9. Install light bulbs (not included).
10. Restore electricity at main breaker.
(continued)