Hubbardton Forge 137710 - Manual (Page 2)

Assembly & Installation Instructions
A126
For Steppe Pendant 13-7710 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19910 Rev A
To Complete Fixture Assembly (Figures 3 & 4)
Component Parts
A Fixture Pipe (2) H Plastic Clutch Sleeve (2)
C Hex Nipple I Set Screw (2)
F Canopy Pipe (2) J Canopy
G Clutch (2)
Caution: Be sure power is off at the main breaker box prior
to installation.
1. Thread wires from the fixture pipe (A) through canopy (J).
Slide canopy (J) down fixture pipe (A) until it rest on top
of fixture.
2. Thread the wires from the fixture pipe (A) into and
through the canopy pipe (F) up through the hex nipple (C).
3. Unscrew the clutch (G) from the canopy pipe (F); slide it
across the wires and onto the fixture pipe (A). Follow this
with the plastic clutch sleeve (H), oriented so the tapered end
of the clutch sleeve nests in the clutch. (Figure 3)
(Figure 3)
(Figure 4)
4. Slide the canopy pipe (F) as far as necessary to give you the total length of
the fixture which you desire. Be careful not to scratch the pipe surfaces and
to pull excess wire up through the canopy pipe (F). Screw clutch (G) onto
canopy pipe (F). There must be a minimum 1-1/2" of inner pipe inside the
outer pipe. Hand-tighten the clutch to temporarily hold this adjustment.
The clutch is not securely fastened at this point; do not depend on it to hold
the fixture.
Important: To ensure full connection strength, be sure the tapered end of
the plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw (Figure 3).
5. Continue with Ceiling Installation below.
(continued)