Hubbardton Forge 137650 - Manual (Page 3)

Assembly & Installation Instructions
A256
For Current Pendant 13-7650 Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24786
3. Install diffuser (O) so it rests on top of center plate
assembly (L) and the notch is against the previously
installed outside plate assembly (N) (Figure 8).
4. Install two 8-32 screws (M) through the top of fixture
(F) and thread into the second outside plate assembly
(N) until snug (Figure 8).
5. Install Bulbs (not included).
6. Install shade (P) from the bottom and tilt so it will
pass fixture (F). Lower the shade so it rests on top of
the fixture.
7. Secure the shade (P) with the thumb screw, washer
and hex nut.
8. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing
any parts, please contact the dealer from which you
purchased this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 7)
(Figure 8)
(Figure 9)