Hubbardton Forge 137620 - Manual (Page 3)

Assembly & Installation Instructions
A300
Facet Pendant 13-7620 Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27150
5. Install bulbs. (Not Included)
See Figure 7 for remaining steps.
6. Remove thumb screw assembly (P) from top
of fixture (Q). Save for later use. Thumb
screws are shipped installed.
7. Install shade (O) from the bottom and tilt so it
will pass fixture (Q). It will be necessary to
raise one side of the shade completely past
the diffuser and over towards the canopy
pipes as far as it will go to allow the other
side of the shade to pass the diffuser. Lower
the shade so it rests on top of the fixture.
8. Secure the shade (O) with the thumb screw
assembly (P).
9. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 7)