Hubbardton Forge 137610 - Manual (Page 2)

Assembly & Installation Instructions
A107
For Intersections Pendants 13-7605 & 13-7610 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19795 Rev A
To Install Fixture
(Figure 4)
Component Parts
C Canopy
I Crossbar
J Threaded stud (2)
K Ground screw
L Knurled ball (2)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Thread studs (J) through appropriate holes in the crossbar
(I) to match hole centers on canopy (C). Move ground
screw (K) to another available threaded hole if necessary.
2. Using two machine screws (not provided), fasten the crossbar (I) to the
electric box using outer oval slots to orient fixture to desired hanging position.
Note: A new electric box comes with screws. When replacing a fixture, retain
the existing screws for use with the new fixture.
4. Using suitable wire connectors (not provided) connect fixture wires to supply
(white to white and black to black). Connect all ground wires to green
ground screw (K).
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
5. Slide fixture canopy (C) with fixture attached, over threaded studs (J) and
push firmly to ceiling making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with the knurled balls (L). Be sure studs (J) are
fully seated in the knurled balls (L).
6. Check fixture for height and level.
7. Once the fixture is fastened to the ceiling, tighten the set screw (Figure 2, G)
firmly with hex wrench provided. Only after the set screw (Figure 2, G) is
tight should you install the glass.
Note: If your fixture has more than one set of pipes or stems in the canopy
you will need to level the fixture. While always leaving one clutch firmly
locked with the set screw, loosen the other(s). Raise or lower the pipe(s) in
the other clutch to obtain plum and level and then tighten the set screw(s).
8. Install light bulbs (not included).
9. Install diffusers; see instructions on next page.
10. Restore electricity at main breaker box.
(continued)
(Figure 4)
(Figure 3)