Hubbardton Forge 137581 - Manual (Page 2)

Installation Instructions
A91
Large Bent Plane Pendant Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19403
4. Slide canopy (F) over canopy pipe (I) being careful not to scratch finish. Slide down until the canopy rests against
clutch (G).
5. Thread studs (B) through appropriate holes in crossbar (A) to match holes in canopy (F).
6. Using at least two lag screws (D) attach cross bar (A) to a structural member in the ceiling, centering the crossbar
over the outlet box. We've supplied lag screws with your fixture; however, different materials and/or construction
methods may require different fasteners. If in doubt, contact a qualified electrician. Do not attach crossbar directly
to outlet box.
7. Push hanger plate (C) at top of assembled fixture up into electrical box, past the crossbar then turn the hanger plate
and drop the threaded studs in the hanger plate into the larger inner holes in the crossbar. Make sure no wires are
pinched. Secure with 1/4-20 nuts (E).
8. Using suitable wire connectors (not provided), connect fixture wires to supply wires (white or ribbed side of fixture
cord to white supply, black or smooth side of fixture cord to black supply, and bare copper to bare copper or green
supply). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
9. Start the threaded studs (B) into the threaded holes in the crossbar.
10. Slide fixture canopy up over the threaded studs (B) and against ceiling. Secure with the two knurled balls (H).
11. Install light bulbs. Be careful not to touch bulb with bare hands. Oil from the hands will dramatically reduce bulb
life.
12. Refer to glass installation instructions and install glass.
13. Restore electricity at main breaker.
(continued)
(Figure 3)
(Figure 4)