A318, Assembly & installation instructions – Hubbardton Forge 137570 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

27845 Rev B

Assembly & Installation Instructions

Prepare the Canopy

(Figure 2)

(Continued)

3. Adjust the length of threaded nipple (E) in crossbar (C) so

that canopy ring (G) will hold canopy (F) against the ceiling

with no threads showing for best appearance.

When the correct adjustment is established, tighten jam nut

(D) against crossbar (C) to hold the adjustment.

4. Remove the crossbar and stem from the electrical box and

proceed with the assembly instructions.

Complete Assembly & Install Fixture

(Figures 3 & 4)

Component Parts

A Fixture Pipe

C Crossbar

D Jam Nut

E Threaded Nipple

F Canopy

1. Place canopy (F) over canopy pipe, followed by canopy

ring (G). Make sure smaller diameter side of canopy ring is
oriented up toward the canopy.

2. Unscrew the clutch (I) from the fixture pipe; slide it across
the wires and onto the canopy pipe. Follow this with the
plastic clutch sleeve (H), oriented so the tapered end of the
clutch sleeve nests in the clutch. (Figure 3).

3. Slide the canopy pipe as far as necessary to give you
the total length of the fixture which you desire. Be careful
not to scratch the pipe surfaces and to pull excess wire
up through the canopy pipe. There must be a minimum
1-1/2" of inner pipe inside the outer pipe. Hand-tighten
the clutch to temporarily hold this adjustment. The clutch
is not securely fastened at this point; do not depend on it
to hold the fixture. Important: To ensure full connection
strength, be sure the tapered end of the plastic clutch sleeve
(H) is oriented toward the clutch (I) when assembled and
securely tighten set screw (J) (Figure 3).

A318

Eddy Pendant 137570

Page 2 of 4

(Figure 3)

LARGER DIAMETER PIPE

TAPERED END OF
PLASTIC SLEEVE

G Canopy Ring

H Crossbar Ground Screw

I Canopy Pipe

J Plastic Sleeve

K Clutch

L Set Screw

CAUTION: BE SURE POWER IS OFF AT THE MAIN
BREAKER BOX PRIOR TO INSTALLATION.

D
E

(Figure 4)

L
K
J

(Continued)