Hubbardton Forge 134915 - Manual (Page 2)

Assembly & Installation Instructions
A263
Staccato Pendants 13-4910 & 13-4915 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21041 Rev A
Complete Fixture Assembly (Figures 3 & 4)
Component Parts
A Fixture Pipe (2)
C Hex
Nipple
F Canopy Pipe (2)
G Clutch
(2)
H Canopy
I
Plastic Clutch Sleeve (2)
J Set Screw (2)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Thread wires from the fixture pipes (A)
through canopy (H). Slide canopy (H)
down fixture pipes (A) until it rests on
top of fixture.
2. Thread the wires from the fixture pipe
(A) into and through the canopy pipe (F)
up through the hex nipple (C).
3. Unscrew the clutch (G) from the canopy
pipe (F); slide it across the wires and
onto the fixture pipe (A). Follow this
with the plastic clutch sleeve (I),
oriented so the tapered end of the clutch
sleeve nests in the clutch. Repeat for
both pipes. (Figure 3).
4. Slide the canopy pipe (F) as far as
necessary to give you the total length of
the fixture which you desire. Be careful
not to scratch the pipe surfaces and to
pull excess wire up through the canopy
pipe (F). Screw clutch (G) onto canopy
pipe (F). There must be a minimum 1-
1/2" of inner pipe inside the outer pipe.
Hand-tighten the clutch to temporarily
hold this adjustment. The clutch is not
securely fastened at this point; do not
depend on it to hold the fixture. Repeat
for both pipes.
Important: To ensure full connection
strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward
the clutch when assembled and
securely tighten set screw
(Figure 3).
5. Continue with Ceiling Installation.
(continued)
(Figure 3)
Illustration may not match every style.
(Figure 4)