Hubbardton Forge 133255F - Manual (Page 3)

Assembly & Installation Instructions
A168
For Vortis Pendant 13-3255F Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21337 Rev A
Install Glass (Figure 5)
Component Parts
Q Glass Retainer
R Tensioning Screw
S Fixture Assembly
T Fixture slot
U Glass
V Retainer
Tab
1. Place glass (U) into glass retainer (Q).
2. Lift glass (U) and glass retainer (Q) up to fixture assembly (S)
aligning retainer tabs (V) with fixture slots (T).
3. Lift so retainer tab (V) slips completely through fixture slot (T).
4. Turn glass (U) and glass retainer (Q) approximately 45 degrees
so glass retainer stays in place.
5. Turn tensioning screw (R) to secure glass retainer (Q) to fixture
assembly (S). Turn until snug and glass retainer will not spin
freely.
The ballast in this fixture is replaceable without cutting wires.
To Replace Ballast (Figure 6)
Caution: Be sure power is off at the main breaker box
prior to replacing ballast.
1. Remove ballast from fixture by inserting a flat bladed
screwdriver behind tabs, located on the side of the
ballast adjacent to the mounting screws, and prying
outward.
2. Attach new ballast to fixture by aligning tabs
snapping it into place For replacement ballast
information, refer to the phone number printed on the
ballast case.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 6)
(Figure 5)