Hubbardton Forge 133255F - Manual (Page 2)

Assembly & Installation Instructions
A168
For Vortis Pendant 13-3255F Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21337 Rev A
3. Thread wires from the fixture pipe (H) through the canopy pipe (G).
4. Slide the canopy pipe (G) as far as necessary to give you the total length of the
fixture which you desire. Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (G). There must be a minimum 1-1/2" of
inner pipe inside the outer pipe. Screw clutch (J) onto canopy pipe and hand-
tighten the clutch to temporarily hold this adjustment. The clutch is not securely
fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward the clutch when assembled and securely
tighten set screw (Figure 2).
5. Using two machine screws (not provided), fasten the crossbar to the electric
box.
Note: A new electric box comes with screws. When replacing a fixture, retain
the existing screws for use with the new fixture.
6. Using suitable wire connectors (not provided), connect fixture wires to supply
wires (white to white or ribbed side of the fixture cord, black to black or smooth
side, and bare copper to bare copper or green supply). Push wires back into
outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire
is exposed.
7. Slide fixture canopy (D) against ceiling, and secure with canopy ring (E).
8. Refer instructions following to install bulb and glass.
Install Bulb (Figure 4)
Component Parts
L Bulb Retainer
M Ballast
N Bulb
O Retainer Plate
P Screw (4)
Q Glass Retainer
R Tensioning Screw
1. Remove glass retainer (Q) from bottom of fixture by removing tensioning
screw (R) and turning the glass retainer 45 degrees to allow it to drop out of the
bottom of the fixture. Set retainer aside.
2. Remove the retainer plate (O) by loosening and removing the four screws (P).
3. Plug connection from ballast (M) to four pin location on bulb (N).
4. Snap bulb (N) in to bulb retainer (L).
5. Replace the retainer plate (O) and the four screws (P) and tighten.
(continued)
(Figure 3)
(Figure 4)