Hubbardton Forge 133255 - Manual

Assembly & Installation Instructions
A166
For Vortis Pendant 13-3255 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21319 Rev B
Prepare the Canopy (Figure 1)
Component Parts
A Jam Nut (2)
B Crossbar
C Threaded
Nipple
D Canopy
E Canopy
Ring
F Coupling
G Canopy
Pipe
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Thread Jam Nuts (A) and Crossbar (B) onto threaded nipple (C) leave parts
loose.
3. Using two machine screws (not provided), temporarily fasten the crossbar (B) to
the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
4. Adjust the length of Threaded Nipple (C) in crossbar (B) so that Canopy Ring (E)
will hold Canopy (D) against the ceiling with no threads showing for best
appearance. When the correct adjustment is established, tighten Jam Nuts (A)
against crossbar (B) to hold the adjustment.
5. Remove the crossbar and stem from the electrical box and proceed with the
assembly instructions.
To Complete Assembly & Install (Figures 2 & 3)
Component Parts
A Jam Nut (2)
B Crossbar
C Threaded
Nipple
D Canopy
E Canopy
Ring
G Canopy Pipe
H Fixture Pipe
I Plastic Clutch Sleeve
J Clutch
K Set
Screw
U Fixture Coupling
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Thread crossbar (B) onto threaded nipple (C) until tight against jam nuts (A).
2. Carefully thread fixture pipe (H) over fixture wires.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)