Hubbardton Forge 132200 - Manual (Page 2)

Assembly & Installation Instructions
A111
For Trestle Four-Light Pendant 13-2200 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19830
4. Slide canopy (F) over canopy pipe (H) being careful not to
scratch finish. Slide down until the canopy rests against
clutch (J).
5. Thread studs (E) through appropriate holes in crossbar (D) to
match holes in canopy (F).
6. Attach crossbar (D) to both canopy pipes (H) using hex nut
nipple (C).
Note: Be sure both swivel notches are aligned in the same
direction. For sloped ceilings the notches should face towards
the down side.
7. Using two machine screws (not provided), fasten the crossbar
(D) to the electric box.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
8. Using suitable wire connectors (not provided) connect fixture
wires to supply (white to white and black to black). Connect all
ground wires to green ground screw.
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
9. Slide canopy (F) over threaded studs (E) and push firmly to
ceiling, making sure that no wires are pinched between
fixture canopy and ceiling. Fasten with knurled balls (G).
Be sure studs are fully seated in the knurled balls.
10. Refer instructions below and install glass/shade for option
that was purchased.
11. Restore electricity at main breaker.
(Figure 3)
(continued)