Hubbardton Forge 132125 - Manual (Page 2)

Assembly & Installation Instructions
A207
Prairie Pendant Three Light 13-2125 & 13-2125F Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22802
2. Unscrew the clutch (J) from the canopy pipe (H); slide it across the
wires and onto the fixture pipe (A). Follow this with the plastic clutch
sleeve (I), oriented so the tapered end of the clutch sleeve nests in the
clutch.
3. Slide the canopy pipe (H) as far as necessary to give you the total length
of the fixture which you desire. Be careful not to scratch the pipe
surfaces and to pull excess wire up through the canopy pipe (H). Screw
clutch (J) onto canopy pipe (H). There must be a minimum 1-1/2" of
inner pipe inside the outer pipe. Hand-tighten the clutch to temporarily
hold this adjustment. The clutch is not securely fastened at this point; do
not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end
of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 2).
4. Slide canopy (C) over canopy pipes (H) being careful not to scratch
finish. Slide down until the canopy rests against clutch (J).
5. Thread studs (F) through appropriate holes in crossbar (D) to match
holes in canopy (C).
6. Attach crossbar (D) to both canopy pipes (H) using hex head nipple (N)
and lock washer (M).
Note: Be sure both swivel notches are aligned in the same direction.
For sloped ceilings the notches should face towards the down side.
7. Using two machine screws (not provided), fasten the crossbar (D) to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
8. Using suitable wire connectors (not provided) connect fixture wires to
supply (white to white or ribbed and black to black or smooth). Connect
all ground wires to green ground screw (E) and cupped washer (L).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
9. Slide canopy (C) over threaded studs (F) and push firmly to ceiling,
making sure that no wires are pinched between fixture canopy and
ceiling. Fasten with barrel knobs (G). Be sure studs are fully seated in
the barrel knobs.
10. Once the fixture is fastened to the ceiling, tighten the set screw (K) in
clutch (J) firmly with hex wrench provided. Only after the set screw (K) is
tight should you install the glass.
11. Refer to instructions below and install glass.
(continued)
(Figure 3)