Hubbardton Forge 131234 - Manual (Page 2)

Installation Instructions
A78
For Almost Infinity Pendant with Duet Shades 13-1224 & 13-1234 Page 2of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19390
To Install Fixture (Figure 3)
Component Parts
A Canopy
G Crossbar
H Threaded
studs
I Threaded Knobs
J Ground screw
Caution: Be sure power is off at the main breaker box prior to installation
1. Thread studs (H) through appropriate holes in
the crossbar (G) to match hole centers on canopy
(A). Move ground screw (J) to another available
threaded hole if necessary.
2. Using two machine screws (not provided) fasten
the crossbar (G) to the electric box using outer
oval slots to orient fixture to desired hanging
position.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
4. Using suitable wire connectors (not provided)
connect fixture wires to supply (white to white
and black to black). Run a pigtail lead from
crossbar ground screw (J) to the junction box
and connect all ground wires (bare copper or
green to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
5. Slide fixture canopy (A) with fixture attached,
over threaded studs (H) and push firmly to
ceiling making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with
the threaded knobs (I). Be sure studs (H) are
fully seated in the threaded knobs (I).
6. Install light bulb(s) (not included).
7. Install Glass Diffusers and Shades (see
instructions following).
(continued)
(Figure 3)