Hubbardton Forge 206540 User Manual

B287, Installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

28806 Rev A

Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Please Note: This fixture is designed to be mounted on a standard

wall surface and may not be suitable for all applications. If installing in

a non-wood frame application, we recommend consulting a qualified

builder or electrician.

To Mount Fixture to Wall

(Figure 1)

Component Parts

A Fixture Assembly

B Wall Mount Bracket

C Anchors (4)

D #10 Screws (4)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Center the wall mount bracket (B) over the electrical box

being sure to hold it plum and level. With a pencil, mark the

location of all mounting holes in the wall mount bracket on

the wall behind.

IMPORTANT: Wall mount bracket must be secured to a solidly mounted
electrical box and/or a framing member in at least two locations. Do
not depend on drywall anchors alone to support this fixture. If in doubt,
contact a qualified electrician.

3. Thread the wires in the electrical box through the center

hole in the wall mount bracket while moving the bracket

into position. Using the #10 screws (D), screw the bracket

securely to the wall. Be careful not to over-tighten or strip

the anchors.

4. Hold the fixture assembly (A) close to the wall mount

bracket and using suitable wire connectors (not provided),

connect fixture wires to supply wires (white to white or

ribbed and black to black or smooth). Ground the mounting

bracket using the green ground screw (F) and cupped

washer (G) to secure a pigtail lead to the bracket and con

nect all ground wires (bare copper or green to bare copper

or green).

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRES ARE EXPOSED.

B287

Pluto Sconce 206540; Vintage Platinum

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)

B
D

E #8 Black Screws (4)

F Green Ground Screw

G Cupped Washer