Hubbardton Forge 306403 - Manual (Page 2)

Installation Instructions
B219
Axis Outdoor Sconce 30-6401 & 30-6403 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26360 Rev A
To Assemble Fixture Front and Glass (Figures 4 thru 7)
Component Parts
A Fixture Front
H Glass
I Hex
Nut
J Threaded Stud
K Glass Bracket
O Spring (Used only on 306403)
1. Place glass (H) on flat clean surface oriented as shown in Figure 4.
2. Place fixture front (A) over glass (H)
(Figure 5).
3. Holding fixture front (A) and glass (H)
securely rotate them both
over so fixture front (A) rests on flat surface.
4. Remove hex nut (I) from threaded stud (J).
5. Slide glass (H) up towards the top of the
fixture.
6. Install spring (O) at the top of the glass (H).
Push spring inside of fixture until it rests
against the top ledge of glass (H). See Figure
6A. Note: This is used on product 306403
only.
7. Slip glass bracket (K) on to threaded stud (J).
See Figure 7 for orientation.
8. Thread hex nut (I) onto threaded stud (J) and
tighten until snug. Be careful not to over tighten.
9. Continue with installation instructions following
to install fixture front.
(continued)
(Figure 4)
(Figure 6)
(Figure 7)
(Figure 5)
(Figure 7)
(Figure 6A)