Hubbardton Forge 206101 User Manual

B312, Assembly & installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

30648

Assembly & Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Please Note: This fixture is designed to be mounted on a standard wall

surface and may not be suitable for all applications. If installing in a non-

wood frame application, we recommend consulting a qualified builder

or electrician.

After installation, extra hardware and accessories may be left due to kits

being used on multiple products.

To Mount Fixture to Wall

(Figures 1 & 2)

Component Parts

A Front Assembly

B Fixture

C Mounting Bracket

D Anchors (4)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Front assembly (A) and fixture (B) are shipped installed.

Parts are held together with a snap clip. To separate,

pull apart. Save parts for later use. (Figure 1)

3. Using two machine screws (not provided), fasten the

mounting bracket (C) to the electrical box.

Note: A new electrical box comes with screws. When replacing

a fixture, retain the existing screws for use with the new fixture.

4. If mounting bracket (C) can’t be mounted to the electrical

box, follow steps 5 through 7 to attach mounting bracket to

the wall using anchors (D).

5. Place the mounting bracket (C) over the electrical box being

sure to hold it plumb and level. With a pencil, mark the

location of all mounting holes in the mounting bracket (C)

on the wall behind.

6. Drill 1/4" holes in the locations marked on the wall. For holes

using anchors, place the tapered end of the anchors (D)

into the holes and gently tap them flush to the wall using a

light weight hammer.

B312

Flux Sconce Vintage Platinum 206101

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 2)

(Continued)

F
G
C
E

E #10 Screws (4)

F Cupped Washer

G Ground Screw

H #8 Black Screws (4)

(Figure 1)

B
H