Allied Telesis AT-MCM02 - Manual (Page 33)

AT-MCM02 Management Module Installation Guide
23
Examples:
The following example resets all of the channels on the media converter:
RESET MC
The reset process takes only a second or two, after which the media
converter is ready again for normal network operations.
If you are managing an AT-MCF12 or AT-MCF112, you can use the
RESET MC CHANNEL command to reset a specific row of channels,
rather than all the channels. The variables “1TO6” and “7TO12” allow you
to specify which row to reset. The following example resets channels 7 to
12:
RESET MC CHANNELS=7TO12
Note
You cannot reset just one channel on a media converter. You must reset
the entire unit or, in the case of an AT-MCF12 or AT-MCF112 unit, a
row of channels.
LOAD Commands
The management module provides several commands for downloading a new
version of the operating software onto the media converter. The commands
are:
❑
SET LOADER
❑ SHOW LOADER
❑
RESTART REBOOT
Note
The software for the AT-MCF Series Media Converters is available from
the Allied Telesyn web site at www.alliedtelesyn.com.