Allied Telesis AT-MCM02 - Manual (Page 30)

20
SHOW SNMP Command
This command displays the current Set, Get, and Trap community strings on
the media converter. This command also displays the IP address of the
management station currently assigned to receive traps from the media
converter.
Format:
SHOW SNMP
MC Commands
The MC commands are used to start and stop link tests on the channels on the
media converter and to reset channels. The commands are:
❑ SHOW MC CHANNEL
❑
SET MC MODE
❑
RESET MC CHANNEL
SHOW MC CHANNEL Command
This command displays the status of the twisted pair and fiber optic ports of
the individual channels on the media converter. The information includes
whether a link exists on the ports, whether there is activity on the ports, and
whether the channel is performing a link test. This command also displays the
operating temperature of the unit.
Format:
❑
SHOW MC CHANNEL=n
Variable:
n: Specifies the number of the channel. For an AT-MCF06 or AT-MCF106
media converter, the value can be 1 to 6. For an AT-MCF12 or AT-MCF112
media converter, the value can be 1 to 12.
Example:
The following example displays the status of all the ports on the media
converter: