Allied Telesis AT-MCM02 - Manual (Page 32)

22
Examples:
The following example starts a link test on all the channels on the unit:
SET MC MODE=TEST
If you are managing an AT-MCF106 or AT-MCF112 media converter, you
can specify a specific row of converters on which to start or stop a link test
rather than all channels. The variables “1TO6” and “7TO12” allow you to
specify the channel row. The following example starts a link test on
channels 7 to 12:
SET MC MODE=TEST CHANNELS=7TO12
Note
You cannot perform a link test on an individual channel.
The following example stops a link test on all channels:
SET MC MODE=NORMAL
RESET MC CHANNEL Command
This command can be used to reset the channels on a media converter.
Note
Resetting a media converter should be performed with caution. Network
operations of the channels will be briefly interrupt during the reset
process.
Format:
RESET MC CHANNELS=row
Parameter:
row: Specifies the row of channels on the media converters to reset.
Possible values are:
1TO6 - Resets channels 1 to 6
7TO12 - Resets channels 7 to 12