Allied Telesis AT-MCM02 - Manual (Page 27)

AT-MCM02 Management Module Installation Guide
17
SHOW IP INTERFACE Command
This command displays the current IP parameters of the media converter.
Format:
SHOW IP INTERFACE
SYSTEM Commands
The AT-MCM02 has two commands for setting and viewing the system name,
location and contact. The commands are:
❑ SET SYSTEM
❑
SHOW SYSTEM
SET SYSTEM Command
This command allows you to specify a name for the system. Assigning names
to the media converters can make it easier for you to identify the individual
units in your network. The media converter name is displayed as part of the
“>” command prompt whenever you manage the device through the RS-232
port or when using Telnet. You can also specify the location of a device and the
name of the network manager responsible for managing the unit.
Format:
SET SYSTEM NAME=”name” LOCATION=”location”
CONTACT=”contact”
Variables:
name: Specifies a name (one word up to 50 characters) for the media
converter.
location: Specifies the location (one word up to 50 characters) of the media
converter.
contact: Specifies the name (one word up to 50 characters) of the network
administrator responsible for managing the media converter.