Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGER - Manual (Page 17)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGER
Starting from SNMPc
Note - SNMPv3: In order to start AT-View Plus Device Manager in SNMPv3 mode, the node's
Read/Write Access Mode attribute should be set to SNMP V3 No-Auth, SNMP V3 Auth-MD5,
SNMP V3 Auth-SHA, SNMP V3 Priv Auth-MD5, or SNMP V3 Priv Auth-SHA, depending on the
SNMPv3 settings configured on the target device.
2.2.2 Starting From HP OpenView Network Node Manager
To start AT-View Plus Device Manager from HP OpenView, select a node on the map window,
then select AT-View Plus > Device Manager from the Tools menu.
Note that AT-View Plus Device Manager and HP OpenView run independently of each other, so
exiting HP OpenView has no effect on AT-View Plus Device Manager. AT-View Plus Device
Manager continues to run even after HP OpenView stops running. To exit AT-View Plus Device
Manager, select Exit from its File menu.
PN 613-50664-00 Rev C Page 17 of 119