Allied Telesis AT-LX3800U - Manual (Page 68)

Chapter 2: Installation
68
Starting a Remote Management Session
The procedure in this section explains how to start a remote management
session using the 10/100Base-TX port on the chassis. You can use a
remote management session to configure the chassis operating
parameters and view system status using the AT-S65 management
software.
To manage a chassis remotely, you must first assign an IP address to it.
For information about assigning an IP address to the system, refer to
Chapter 1, “Getting Started,” in the AT-S65 Management Software User’s
Guide.
To start a remote management session, perform the following procedure:
1. Connect a twisted pair cable to the 10/100Base-T port on the front of
the chassis, as shown in Figure 45.
Figure 45. Connecting a Cable to the 10/100Base-T Port
Note
The RJ-45 port runs in MDIX mode. Be sure to use the proper cable.
The connector and port pinouts are shown in “10/100Base-TX Port
Pinouts” on page 78.
2. In the Telnet application, specify the IP address of the AT-LX3800U
chassis that you want to access.
The software initializes and then the Login prompt is displayed.
3. To configure chassis settings, enter “manager” as the user name. To
only view the settings, enter “operator” as the user name.
The Password prompt is displayed.
TX
CLASS 1 LASER P RODU CT
10/100Base-TX
RS-232
TERMINAL
FT
CO
PA
PB
8
RESE T
AT-LX3800U
8
LINE
C
LINE
AT-LX3811/8
SFP
SYNC
TX
RX
LINE
RDY
TX
RX
TRIB RX
100 10
155