Allied Telesis AT-LX3800U - Manual (Page 4)

4
Laser Warnings
Pluggable Transceivers
For continued compliance with the above laser safety standards, use only UL recognized or other
safety agency certified Class 1 small form-factor pluggable (SFP) transceivers. The following SFP
transceiver models are available from and supported by Allied Telesyn:
AT-SPSX
AT-SPLX10
AT-SPLX40
AT-SPZX80
AT-SPZX80/1470
AT-SPZX80/1490
AT-SPZX80/1510
AT-SPZX80/1530
AT-SPZX80/1550
AT-SPZX80/1570
AT-SPZX80/1590
AT-SPZX80/1610
Refer to the Allied Telesyn web site, www.alliedtelesyn.com, or an authorized Allied Telesyn sales
representative for a current list of supported SFP modules for this unit.
Caution
- Using controls, making adjustments to performance, or performing procedures other than
those specified herein may result in hazardous radiation exposure.
- The protection provided by the equipment may be impaired if the equipment is used in a
manner not specified by Allied Telesyn.
- Do not remove the cover from the unit or change any of the internal cables or wiring. Only
an authorized Allied Telesyn service technician should make repairs to this device.
- The TX and RX multiplexing ports contain embedded Class IIIb lasers operating in Class I
compliance. Do not make any modifications to the unit that would override the safeguards
that maintain the Class I compliance.
- The laser light used by the multiplexing ports and SFP modules is invisible. Standard
safety precautions (e.g. avoid looking directly into a fiber optic port) should always be
observed when installing or maintaining this product.