Allied Telesis AT-LX3800U - Manual (Page 60)

Chapter 2: Installation
60
Powering On an AC Powered System
To power on an AC powered chassis, perform the following procedure:
1. Make sure that the on/off switch is in the Off position, as shown in
Figure 35.
Figure 35. On/Off Switch in Off Position
2. Position the power cord retaining clip in the up position, as shown in
Figure 36.
Figure 36. Power Cord Retaining Clip in the Up Position
PWR A
AT-LXPWRA
C
100-240V
AC ~
ON
PWR A
AT-LXPWRA
C
100-240V AC ~
ON