Allied Telesis AT-LX3800U - Manual (Page 64)

Chapter 2: Installation
64
3. With a 14-gauge wire-stripping tool, strip the three wires in the tray
cable coming from the DC input power source to 8mm ± 1mm (0.31 in.,
± 0.039 in.).
Figure 41. Wire Stripping Specification
4. Connect the frame ground wire to the terminal marked with the
ground symbol by inserting the wire into the terminal and tightening the
connection with a flathead screwdriver, as shown in Figure 42.
Figure 42. Connecting the Stripped Wire
5. Connect the positive feed wire to the terminal block marked (+).
Warning: Do not strip more than the recommended amount of
wire. Stripping more than the recommended amount can create
a safety hazard by leaving exposed wire on the terminal block
after installation.
12
Warning: When installing this equipment, always ensure that
the frame ground connection is installed first and disconnected
last.
13
8mm ±1mm
(0.31in. ±0.039 in.)
705