Allied Telesis AT-LX3800U - Manual (Page 66)

Chapter 2: Installation
66
Starting a Local Management Session
The procedure in this section explains how to start a local (out-of-band)
management session using the RS-232 terminal port on the chassis. You
can use a local management session to configure the chassis operating
parameters and view system status using the AT-S65 management
software.
Note
Only one manager can log in at a time.
To start a local management session, perform the following procedure:
1. Connect the DIN-8 end of the management cable included with the
AT-LX3800U chassis to the RS-232 terminal port on the front of the
chassis, as shown in Figure 43.
Figure 43. Connecting the Local Management Cable to the Terminal Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulation program.
3. Configure the terminal or terminal emulation program to the following
settings:
ˆ Baud rate: 115200 bps
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
TX
CLASS 1 LASER PRODUCT
10/100Base-TX
RS-232
TERMINAL
FT
CO
PA
PB
8
RESET
AT-LX3800U
8
LINE
C
LINE
AT-LX3811/8
SFP
SYNC
TX
RX
LINE
RDY
TX
RX
TRIB RX
100 10
154
154