Allied Telesis AT-LX3800U - Manual (Page 45)

AT-LX3800U Multi-Service Transport System Installation and Maintenance Guide
45
Installing the Power Cord Retaining Clip (AC Power Supply Only)
To install the power cord retaining clip on an AC powered system, perform
the following procedure:
1. Locate the power cord retaining clip, as shown in Figure 15.
Figure 15. Power Cord Retaining Clip
2. Locate the retaining bracket on each side of the AC power connector
on the back of the chassis, as shown in Figure 16.
Figure 16. Power Cord Retaining Bracket
3. With the “u” of the clip facing up, press the sides of the clip toward the
center and insert the short ends into the holes in the retaining bracket,
as shown in Figure 17.
Figure 17. Inserting the Retaining Clip into the Retaining Bracket
PWR A
473
AT-LXPWRA
C
100-240V AC ~
ON
Bracket
PWR A
474
AT-LXPWRA
C
100-240V
AC ~
ON