Allied Telesis 9400 iMAP - Manual (Page 13)

Install the PEM7 Install Cards into Chassis
1-9
Telesyn x400 - Installation Guide (Installation of ATI 9400)
1.6 Install Cards into Chassis
Note: Do not attempt to install system cards without observing correct antistatic procedures. Failure
to do so may damage cards.
Note: Insure that all cards are seated properly. A card that is only partially connected to the
backplane may affect system operation.
The following cards are installed into the chassis prior to installing the chassis into the rack:
• Power Entry Module (PEM7)
• Fan Controller (FC7)
• Fan Module (FM7)
1.6.1 Install the PEM7
1. Take the card from its antistatic container.
2. If possible, place the chassis vertically on a flat secure surface. This makes inserting the PEM7 easier.
3. Slide the PEM7 into the bottom-right of the chassis until it lines up with the backplane connector on the right.
4. Slowly press the PEM7 with the thumbs until the PEM7 is fully inserted into the backplane and the flange is
flush against the screw holes of the chassis.
5. Using a small head (#1) phillips screwdriver, take the provided screws and attach the PEM7 to the chassis.
1.6.2 Install the FC7
1. Take the card from its antistatic container.
2. Hold the card securely (such as holding it in one hand with your fingers on the outside rim), component side
up.
3. Press the release button on the inside of the latch and push the latch out. (Refer to Figure 1-14.)
4. While holding the latch/faceplate, slowly but firmly push the card into the slot until the latches begin to
engage the locking rail.
5. Close the latches until they lock into place.
1.6.3 Install the FM7
1. Take the fan assembly from its antistatic container.
2. Press the lock-latch in the middle of the faceplate, and ensure the bottom half of the faceplate drops. (Refer to
Figure 1-4 and Figure 1-5.)