Allied Telesis 9400 iMAP - Manual (Page 11)

ESD and Antistatic procedures Mounting Procedure
1-7
Telesyn x400 - Installation Guide (Installation of ATI 9400)
1.4 Mounting Procedure
1.4.1 ESD and Antistatic procedures
Proper ESD protection is required when handling equipment. Installation and maintenance personnel should be
properly grounded using ground straps to eliminate the risk of ESD damage to the equipment.
1. Whenever dealing with electrostatic-sensitive equipment, wear a ground or foot strap.
2. Ensure customer power source for the product is off.
1.4.1.1 Antistatic procedures:
1. Verify that the chassis is electrically connected to earth ground.
• Wear an ESD-preventive device such as a foot strap or wrist strap, ensuring that it makes good contact
with the user’s skin. If a foot strap is used, the floor must be ESD conductive.
2. Connect the clip from the ESD-preventative device to an unpainted surface of the frame, rack or ESD
point on the chassis frame connecting it directly to ground. This ensures that unwanted ESD voltages
safely flow to ground.
3. Wear the ESD-preventive device correctly to properly guard against ESD damage and shock. If no foot or
wrist strap is available, the user should ground themselves by making contact with an unpainted, metal
part of the chassis.
1.5 ATI 9400 Installation
Installation and power up of the ATI 9400 follows.
1.5.1 Setup Checklist
Table 1-3 lists the items that are to be provided by the customer.
TABLE 1-3 Customer Item Checklist
Item Quantity Description
MGMT cable 1 RJ-45, connectorized at one end, Cat 5
Bay Power
Cabling 12 awg, length determined by shelf position and how cabling is routed
Alarm cable 3 RJ-45, connectorized at one end, cat 5
Bolt 6 M6 (Number depends on how shelf mounted)