Allied Telesis AlliedView-EMS 3.10 QoS MANAGER - Manual (Page 90)

Property Name Description Valid Values
decimal number in the
range 0 to 37. This
specifies the location of
the byte to match. It
refers to the offset from
the start of Layer 5, after
the UDP or TCP header.
• bytevalue, which is a 2-
digit hexadecimal
number. This specifies
the value of the byte at
the position in the frame
that is determined by
byteoffset. The classifier
matches packets that
have this value at this
location.
• (optionally) bytemask,
which is a 2-digit
hexadecimal number.
This specifies an eight-bit
binary mask to apply to
the field. When a bit is
set to 1 in the mask, the
value of the bit at the
same position in the byte
value is used to
determine a match. A 0
in the mask means that
the corresponding bit is
ignored. The default is ff,
which means the
classifier matches against
all bits in the byte.
TCP Flags Specifies the TCP flags of an
IPv4 or IPv6 packet. This can be set by selecting one
or more of the following values:
• URG
• ACK
• RST
• SYN
• FIN
This can also be set to "any".
ICMP Type Specifies the ICMP type of an This can be set by selecting any
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 90 of 128