Allied Telesis AlliedView-EMS 3.10 QoS MANAGER - Manual (Page 109)

Property Name Description Valid Values
This value can also be set to
"any".
MAC Type Specifies the type of destination
MAC address on the frame. • L2UCAST
• L2BMCAST
• any
Protocol Specifies the protocol of the
packet This can be set by selecting any
of the following values:
• IP
• IPv6
• ARP
• IPX
• NONIPIPX
• any
This can also be set by entering
a 1- to 5- byte hexadecimal
value (00-FFFFFFFFFF).
Frame Relay
Data Link
Connection ID Specifies the identification
number of a Frame Relay Data
Link Connection (DLC). Range: any, 0-1023
PPP Index Specifies the PPP interface
number. This can be set by selecting a
pre-defined PPP interface ID
number.
PPP Protocol
ID Specifies the network layer
protocol of the PPP
encapsulated packet. This can be set by selecting any
of the following values:
• IP
• IPv6
• any
This can also be set by entering
a 4-byte hexadecimal value
(00000000-FFFFFFFF).
Source IP
Address Specifies the source IP Address
(either host or host/subnet) of
an IP packet
This can be set by entering an
IPV4 or IPV6 address using the
following format:
• IPv4 address[/mask] -
IPv4 is in dotted decimal
notation, mask is 0..32.
• IPv6 address[/mask] -
IPv6 is in colon separated
hex digit notation, mask
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 109 of 128