Allied Telesis AlliedView-EMS 3.10 QoS MANAGER - Manual (Page 63)

Property Name Description Valid Values
mask, the value of the bit at the
same position in the byte value
of the MAC address is used to
determine a match. If a bit in
the Source MAC Address
parameter is 0, the
corresponding bit in the Source
MAC Address parameters is
ignored.
• XX-XX-XX-XX-XX-XX
This can also be set to "any".
Destination
MAC Address
Mask Specifies the masks to be used
on the Destination MAC
Address. When a bit is set to 1
in the mask, the value of the bit
at the same position in the byte
value of the MAC address is
used to determine a match. If a
bit in the Destination MAC
Address parameter is 0, the
corresponding bit in the
Destination MAC Address
parameters is ignored.
This can be set by entering a
MAC address string using the
following format:
• XX-XX-XX-XX-XX-XX
This can also be set to "any".
MAC Type Specifies whether the packet is
a Layer 2 unicast (L2UCAST),
Layer 2 multicast (L2MCAST)
or Layer 2 broadcast Ethernet
(L2BCAST).
• L2UCAST
• L2MCAST
• L2BCAST
• any
Tag Protocol
ID Specifies the Tag Protocol
Identifier field in the packet. This can be set by entering a 4
digit hex number from 0000-
FFFF.
This can also be set to "any".
VLAN Priority Specifies the 802.1P priority in
the VLAN tag.
Range: any, 0-7
VLAN Specifies:
• For IPv4 packets and
switched Layer 2 IPv6
packets, the source
VLAN that the packet
was associated with at
the time of classification.
• For accelerated IPv6
packets at the Layer 2
processor of the
accelerator card, the
This can be set by selecting
from a list of available VLANs
or "any".
AlliedView™-EMS 3.10 QoS Manager User’s Guide Page 63 of 128