Campbell Scientific LoggerNet-SDK Software Development Kit - Manual (Page 49)

Section 9. Developing an Application Using the Datalogger Control
Private Sub cmdRetrieve_Click()
'Get the current program from the datalogger
If DataLogger.serverConnected Then
DataLogger.programReceiveStart
txtRetrieve
WriteMessage "Retrieving Program from the Datalogger"
Else
WriteMessage "Not connected to the LoggerNet server"
End If
End Sub
The programSendStart() method sends a program to the specified datalogger
and calls the onProgramSendProgress() event, the onProgramSent() event, and
the onProgramSendComplete() event respectively. The following table
contains example code for the programSendStart() method:
Private Sub cmdSend_Click()
'Send a program to the datalogger
If DataLogger.serverConnected Then
If txtSend = "" Then
WriteMessage "Enter a Program to Send"
Else
DataLogger.programSendStart txtSend, ""
WriteMessage "Sending Program " & txtSend
End
If
Else
WriteMessage "Not connected to the LoggerNet server"
End
If
End Sub
Additional functionality, error handling, and objects should be added as
necessary beyond the example interface and code listed above to meet the
specific requirements of your application. Complete examples using the
CsiDatalogger control are included in the LoggerNet SDK installation.
9-7