Vaisala WXT510 - Manual (Page 62)

User’s Guide ______________________________________________________________________
60 __________________________________________________________________ M210470EN-D
To change the parameters and units in the response message and to
make other sensor settings, see section
Wind Sensor on page 93 .
Pressure, Temperature and
Humidity Data Message (aR2)
With this command you can request a pressure, temperature and
humidity data message.
Command format: aR2
Example of the response (the parameter set is configurable):
0R2,Ta=23.6C,Ua=14.2P,Pa=1026.6H
To change the parameters and units in the response message and to
make other sensor settings, see section
Pressure, Temperature, and
Humidity Sensors on page 99 .
Sx = Wind speed maximum (M = m/s)
= Response terminator
where
a
= Device address
R2 = Pressure, temperature and humidity message query
command
= Command terminator
where
a
= Device address
R2 = Pressure, temperature and humidity query command
Ta = Air temperature (C = °C)
Ua = Relative humidity (P = % RH)
Pa = Air pressure (H = hPa)
= Response terminator