Vaisala WXT510 - Manual (Page 55)

Chapter 7 __________________________________________________ Getting the Data Messages
VAISALA _______________________________________________________________________ 53
CHAPTER 7
GETTING THE DATA MESSAGES
This chapter presents the general and data message commands.
Each communication protocol has its own section for data message
commands.
For changing the message parameters, units and other settings, see
Chapter 8, Sensor and Data Message Settings, on page 93 .
General Commands
In case the error messaging is disabled (see Supervisor Message on page
108 ), WXT510 does not return any response message with the general
commands given in ASCII and NMEA-formats.
Reset (aXZ)
This command is used to perform software reset on the device.
Command format in ASCII and NMEA 0183: aXZ
Command format in SDI-12: aXZ!
NOTE Type commands in CAPITAL letters.