Gmp231 parts, Figure 2, Caution – Vaisala GMP231 User Manual
Page 16
User's Guide _______________________________________________________________________
14 ___________________________________________________________________ M211501EN-C
GMP231 Parts
1403-153
Figure 2
GMP231 Parts
1 = Electronics housing. Contains the main component board,
including the digital pressure sensor.
2 = Holes for M4 screws on both sides of the housing.
Maximum screw depth 8 mm. Two screws included, type
BN 10649 M4.
3 = Type label on housing cover (not shown).
4 = 8-pin M12 connector. For pinout, see Table 4 on page 24.
5 = Probe body.
6 = Measurement cuvette with optics and CARBOCAP
®
CO
2
sensor.
7 = PTFE filter.
8 = Silicone plug for sealing the lead-through.
Recommended accessory, suitable for
⌀ 44 mm lead-throughs.
CAUTION
Do not open the electronics housing; there are no user serviceable parts
inside. All wiring is done through the M12 connector (4).
3
2
4
1
5
6
7
8