Apple Workgroup Server 8550 - Manual (Page 68)

10 Replace the cover on the server.
Lower the cover all the way down onto the case. Push the cover toward the
back until it touches the back panel.
11 Tighten the screws on the back panel.
If a software driver was included (on a floppy disk) with your new drive, after
you finish setting up your server and turn it on, you will need to install the
driver. You may also need to initialize a newly installed hard disk. See the
sections “Installing a Device Driver” and “Do You Need to Initialize a Hard
Disk?” later in this chapter.
Return to Chapter 1 to complete the steps for setting up and turning on your
server.
WARNING Never turn on your server unless all of its internal and
external parts are in place. Operating the server when it is open or
missing parts can be dangerous, and can damage your server.
Connecting hard disks and other SCSI devices 59