Apple Workgroup Server 8550 - Manual (Page 47)

7 Press the card firmly until the connector is seated.
m Slide the card between the two levers that held the access port cover you
removed earlier. You may need to press the levers apart slightly to guide the
card between them.
m Don’t force the card. If you meet a lot of resistance, pull the card out and
try again.
m To see if the card is properly connected, pull it gently. If it resists and stays
in place, it’s connected. (Make sure you don’t pull the card so much that
you accidentally disconnect it.)
If you have other cards to install, put them in now by repeating steps 4 through 7.
8 Replace the retainer.
When the card is properly seated, the levers
snap into place and secure the card.
This guide on the retainer
engages the processor card
in the server.
Snap the retainer
back into place. Processor card
38 Chapter 3 / Expanding Your Server and Connecting Other Equipment