Apple Workgroup Server 8550 - Manual (Page 62)

12 Replace the cover on the server.
Lower the cover all the way down onto the case. Push the cover toward the
back until it touches the back panel.
13 Tighten the screws on the back panel.
If a software driver was included (on a floppy disk) with your new hard disk,
after you finish setting up your server and turn it on, you will need to install
the driver. You may also need to initialize the new hard disk. See the sections
“Installing a Device Driver” and “Do You Need to Initialize a Hard Disk?”
later in this chapter.
Return to Chapter 1 to complete the steps for setting up and turning on
your server.
WARNING Never turn on your server unless all of its internal and
external parts are in place. Operating the server when it is open or
missing parts can be dangerous, and can damage your server.
Connecting hard disks and other SCSI devices 53