Apple Workgroup Server 8550 - Manual (Page 48)

9 Replace the cover on the server.
Lower the cover all the way down onto the case. Push the cover toward the
back until it touches the back panel.
10 Tighten the screws on the back panel.
You are now finished installing the card. If a software driver was included
with your expansion card (on a floppy disk), after you finish setting up your
server and turn it on, you will need to install the driver.
Return to Chapter 1 to complete the steps for setting up and turning on your
server, and then, if you need to install driver software, refer to the
documentation that accompanied the expansion card and to “Installing
Device Drivers” in Chapter 1 of the Workgroup Server Administrator’s Guide.
WARNING Never turn on your server unless all of its internal and
external parts are in place. Operating the server when it is open or
missing parts can be dangerous, and can damage your server.
Installing an expansion card 39