GReddy Profec - Manual (Page 37)

SCRAMBLE
・SELECT
・SET
・GAIN
・START
(START BOOST)
・SW. MODE
(SWITCH MODE)
・TIME
・PEAK
・WARNING
・LIMITER
・・・・
・・・・・・
・・・・・
・・・・
・・・
・・・・・
・・・・・
・・・
・・・・
Recall & Reset the highest recorded PEAK boost value.
■Programming the SCRAMBLE feature■
SELECT
SET
SET
Boost settings
SCRAMBLE is an ENHANCED BOOST feature that can be activated by pressing the SET
DIAL. SCRAMBLE can be momentarily or adjusted to a preset length of time that can
be activated from the Real-time BOOST LO or BOOST HI mode.
The following items can be programmed from the SCRAMBLE set-up screen.
There is only one SCRAMBLE feature for both BOOST LO & BOOST HI mode.
Mode s set up screen
SELECT OFF
Mode s set up screen
SELECT ON
(1) In the BOOST HI set-up screen, press the MODE button,
then press the SELECT button. This will bring you to the
SCRAMBLE set-up screen. Turn the SET DIAL to SELECT (on
the screen) to choose to turn ON or OFF the SCRAMBLE
feature. Refer to page 29. The factory default is set to OFF.
(2) Turn the SET DIAL to ON and then press the SET DIAL to
confirm. * To cancel and return to the previous setting and
the BOOST HI mode set-up screen, press MODE.
(3) When SCRAMBLE SELECT (on the screen) is ON, this
allows you to view and change the SCRAMBLE set-up
screen.
Turns ON / OFF the SCRAMBLE boost mode.
Program a SET % value. Refer to page 30.
Program a GAIN % value. Refer to page 31.
Program a START BOOST pressure value. Refer to page 32.
Configures how the SCRAMBLE mode is activated. Refer to page 37.
Program the duration of time the SCRAMBLE mode is in use once activated.
Refer to page 37.
Program a LIMITER % to reduce boost once over the WARNING value.
Refer to page 35.
Program a boost value when the WARNING alarm is activated.
Refer to page 34.