GReddy Profec - Manual (Page 17)

Installation
Control Unit Installation
Once the electrical wiring is complete, find a suitable mounting location for the
Control unit. You may use the provided Adjustable bracket or flush mount the unit
with the provided double sided tape.
Warning
For safety, avoid mounting the unit near air-bags.
Caution
When using the double-sided tape, clean mounting surfaces from oil and
debris with a mild detergent for best results.
Important
Be sure to mount the unit in a safe location that will not effect safe driving.
Avoid direct sunlight and humidity.
Route the harness between
the bracket uprights
as shown.
■How to install■
(1) Adjust the angle of mounting
bracket to find the best position
of controller. Tighten left & right
bracket bolts with hex wrench.
( 2 ) P l a c e c o n t r o l l e r i n t h e
adjustable bracket. Attach the
back of the controller into the
relief in the bracket until it locks
into place. The controller can be
inverted, so that the dial on right
side or left side.