GReddy Profec - Manual (Page 23)

PATTERN
Configure the Real-time (boost gauge) display settings type (for BOOST LO, HI,
SCRAMBLE, and OFF modes).
DIGIT
SET UP
BAR GRAPH
PATTERN
■Programming■
1. Boost Mode (LO, HI, or SCRAMBLE)
2. Numeric Real-time boost reading.
3. Peak value - the reading will blink for 3 seconds when the value is updated
4. Units (kPa or PSI)
5. Boost reading - The reading will display negative and positive pressures.
6. (0PSI)
7. GRAPH display ‒ The map tracing will display the past 10 seconds (above the programmed Graph Minimum Value)
SET
When GRAPH is selected.
★Refer to page 38 for shortcuts.
2 4
1 2
3 4
1 2
3 4
5 6 1
7
3
Configurations
(1) Rotate the SET DIAL to highlight PATTERN in the
SETUP screen. Then press the SET DIAL to confirm.
(2) Rotate the SET DIAL to select a Real-time (boost
gauge) display pattern. (DIGIT / BAR / GRAPH) Press the
SET DIAL to confirm.
* To cancel and return to the previous PATTERN setting
and the main SET UP screen, press MODE
Once the GRAPH display is confirmed, the GRAPH SET UP screen will appear.
Turn the SET DIAL to select the Graph Minimum Value. Then press the SET DIAL
to confirm. (any boost pressure over this Graph Minimum Valve will be charted
on the GRAPH display, readings under will not be shown.)
Setting ranges: 0 3.00 x 100kPa