GReddy AIR INTAKE SYSTEMS: Subaru WRX STI 2002-07 - Manual

Installation
Kit P/N:
12569002 (POLISHED)
Make:
Subaru
Model: Year: Engine:
Impreza WRX ’02-’07 H4-2.0L AWD
Impreza WRX STI ’04-’07 H4-2.5L AWD
1
Complete Stock intake. Please disconnect battery
terminals before installation.
2
Disconnect MAF sensor. Loosen clamps on intake tube
using 5/16” nut driver.
3
With 12mm socket or wrench loosen the bolt on frame
and save for install of housing tab.
7
Install housing into vehicle and postion tab to frame
and bolt from step 7. Tighten using 12mm socket or
wrench.
8
With screw and washer provided, tighten top of
housing tab to inside of fender using 10mm socket or
wrench.
9
Pull back vacuum lines on top of air box. Remove
upper half of air box with intake tube.
4
With 12mm socket or wrench, loosen the 2 bolts
securing bottom half of air box and remove.
5
Install filter adaptor to housing using supplied button
head screws and wavy washers. Tighten using 4mm
allen key.
6
06-80505 Pg1
Parts Identification:
1 Air filter ( ™ 61-90133)
1 Intake tube, 05-T4302P1
1 Adaptor, 3-angle filter
1 Cover, 05-T4302B3
1 Housing, 05-T4302B2
1 Coupling, reducer 05-00649
1 Coupling, straight 05-00417
3 Clamp #044
1 Clamp #064
8 Button head screws M6
5 Wavy washer M6
2 Screw M4 x .7 x 8
Tools Required:
10mm socket or wrench
12mm socket or wrench
Ratchet w/ extension
Phillips screw driver
Flat head screw driver
5/16” nut driver
Pliers
4mm allen key
Note: Read instructions before
installation and have tools ready.